Leg Installation

IF YOUR TABLE HAD BEEN SHIPPED VIA TRANSPORT, YOU WILL BE RESPONSIBLE FOR THE INSTALLATION OF THE LEGS! TABLES WILL NOT BE SHIPPED WITH LEGS INSTALLED. 

Please follow these steps and call Eddie if you have any questions prior to attempting to install. (416)-358-1778 

Please note that on any transport of goods we are working on your behalf and can only provide you with the same info given from the transporter. Tree Green Team is not responsible for lost or damaged goods during transport.

Tools you will need: 

1. Impact gun or impact drill (not a regular drill as it will snap the screws).

2. 7/16 impact drive bit. Screws and washers will be supplied inside your shipment.

3. You will need help to flip the table. We suggest a minimum of two men.

Make sure table is bottom up where you can see the pilot holes. Best to place on work horses (make sure there is blankets to protect the top) or if the piece is small enough you can use a carpeted floor. You will notice that the legs prior to unwrapping should be taped indication a,b or 1,2. Align the pilot holes with the pre-drilled holes. Before attempting to drill into the pre drilled holes make sure that all the holes align perfectly.

Manually insert the screws provided in all holes to make sure that alignment is proper. Once aligned properly use a impact gun to install the lag screws SLOWLY. If you feel a lot of resistance back off and go forward again. Washers should not be loose when properly installed. Should be snug against the screw and the material of the leg.

It is a two man job to flip the table over. Will need to be done in the air or on work house so that there is no weight on the table legs. The screws will snap if any pressure is put on the legs.

Please call or email Eddie if you have any questions at all. Please do not to attempt to install the legs if you are unsure of any of the directions.